Gun Talk Vepr FM-AK47-11 folding trunnion rivets

Could you get the dimensions of the receiver and compare the dimensions to a standard AKM receiver? I should have a surplus NOS Polish AKM rivet set from AoA, if you're interested or think it would work with your rifle I can get some dimensions, and if it seems like it would work I could mail them to you for like $5. I also have standard AKM receiver dimensions I can get to you if you need them. I'm not an AK expert by any means, so I apologize if I'm way off

3030WCF:

Could you get the dimensions of the receiver and compare the dimensions to a standard AKM receiver? I should have a surplus NOS Polish AKM rivet set from AoA, if you're interested or think it would work with your rifle I can get some dimensions, and if it seems like it would work I could mail them to you for like $5. I also have standard AKM receiver dimensions I can get to you if you need them. I'm not an AK expert by any means, so I apologize if I'm way off

Click to expand...

I'm getting 1.33 to 1.35" on the width from top to bottom. I can only assume that the existing fixed trunnion was jammed in there forcing the side walls out causing the slight deviation. The two flanges on the folding trunnion that the rivets needs to go thru are 0.105" (2.7mm) thick. So... With complicated math.. 1.5mm + 2.7mm = 4.2mm. That's the thickness of the material the rivet needs to clear. There will be 3 holes total. 4 short rivets for tow of the holes + the axis pin that goes straight across on the existing 3rd hole. I BELIEVE the axis pin is 4mm. I do not know. I'll have to assume it's the same as the AKM. Since I'm going in blind and not privy to vepr blueprints, then I'll make the rules on rivet sizes and copy AKMs. 😁

I'm willing to bet the rivets are the same as the RPK. The vepr I have is basically an RPK.